Hi Karthiga
Did you set the ASMA properties in both your sender JMS channel and receiver File channel?
For the JMS adapter, as shown below, you will need to enter the DCJMSMessageProperty4 into the table
- If you want to set additional JMS message attributes, select Specify Additional JMS Message Properties (Maximum of 10).
In the table, enter the names of the JMS message properties whose values are to be included in the message header of the PI message.
The technical names of the additional attributes are DCJMSMessageProperty0, DCJMSMessageProperty1, ..., DCJMSMessageProperty9.
For the File adapter, you need to check the ASMA FileName attribute.
Once you have this configured, in your message, you should be able to see that the value is in the DynamicConfiguration section of the SOAP header.
Rgds
Eng Swee